You'll Never Guess This How Much Is A Ghost Immobiliser's Secrets > 자유게시판

Ghost 2 Immobiliser Problems

The Ghost 2 immobiliser, designed to safeguard cars from hacking or key cloning, is a discrete device that can be installed without damaging your vehicle. It stops your car from starting unless you enter a specific sequence of buttons inside your vehicle, similar to a password on the phone.

Stop/Start

Ghost immobilisers protect vehicles from being stolen by stopping the engine from starting until it is issued the correct PIN code. This is done without modifying the vehicle, and is not detected by thieves. The unit communicates with the ECU via the CAN data bus to immobilise the vehicle. This is similar to the ones used by car manufacturers for many years. However, thieves cannot escape it using a new key, or key relay technology, like they can do with factory fitted systems.

A Ghost can be fitted to any vehicle, van motorhome, caravan, or bicycle with an engine and is compatible with all popular makes of vehicles. The same system is also compatible with electric cars. It's a great alternative to locking the steering wheel and wheel clamps and can be installed with a minimum of effort.

When the Ghost is armed it will block all buttons in your car and stop the ignition from starting unless a PIN code has been entered first. This can be done using the Android or Apple mobile apps or by entering the code through your key fob. If a code that is incorrectly entered, the app will show an indicator light and the Ghost will not allow the vehicle to be started again. This is a great deterrent and when the vehicle isn't started the thief will continue to pursue a new target.

The Ghost is a small weatherproof device that can be concealed in the most difficult-to-access parts of your car. The installation process takes between 20 and 30 minutes for each vehicle. It is also very easy to remove if you decide to switch your vehicle or hand it in to valet parking or service. It is a TASSA (Tracking and Aftermarket Security Systems Association) insurance approved system that is endorsed by some insurers. It also has a safe emergency Pin Code override and features a Service/Valet mode that can be activated by pressing an app button or with your key fob.

Disarm

Ghost immobilisers, unlike mechanical anti-theft devices that are able to be removed, are hidden inside the vehicle. Even if they were discovered, thieves would not be able to start the vehicle. They are almost impossible to hack or bypass. This is because ghost 2 immobiliser review immobilisers prevent key hacking, signal jamming and device spoofing, all of which are methods that are commonly used by thieves to gain entry into vehicles that have standard immobilisers.

An immobiliser works by sending an instruction to the ECU (electronic control unit). If a incorrect code is received, the vehicle cannot be started because the engine will not fire up. Although it is possible to disable the ghost immobilise immobiliser by using software, it is laborious and time-consuming. The software can only be installed and used by an authorised installer.

The Ghost immobiliser is a tiny device that is part of the wiring loom of the vehicle and is not visible to the naked eye after it has been installed. It doesn't show up on diagnostic systems. There are no LED indicators, and it isn't able to communicate with the engine via the OBD port. It communicates silently through the CAN data circuit.

The system will not allow the vehicle to start until it is given an input PIN code that is entered by the user. The code is entered by pressing buttons on the steering wheel, door panels, or centre console. This is a safer way to protect the car, as it doesn't require an additional remote control or key fob.

Ghost also has a service mode that is activated through the mobile application. This allows you to give your keys to someone else to use for valet parking or service without the need to enter a disarm sequence.

You should never remove the system from your Ghost by yourself, regardless of whether it is in service mode. This could cause damage to your engine. It is recommended to contact a TASSA certified installer who will be able to remove the system safely and properly. Our newest GHOST immobilisers have a specific fingerprint QR sticker hidden in different parts of your vehicle. They are linked to our security register. If the system is removed and then sold on the blackmarket this will allow you to trace the owner of the system.

Anti-Hijack

The anti-hijack function is a very important feature of the Ghost Immobiliser 2. This is a sophisticated key that protects your car from theft. If the ignition switch is switched to on, and the vehicle is stationary for a period of 30 seconds then the Ghost system will automatically stop the engine and turn the hazards lights on. This gives the driver or passengers enough time to press a security button (depending on the vehicle) before the system reactivates and the engine is again allowed to begin.

Contrary to many other systems that simply stop the engine whenever the ignition switch is turned on and on, the Ghost system uses a special controller and timer unit which will close the fuel cut-off valve 14 if it is activated after the set time, even if the ignition is still switched on! This delay time period must be sufficiently long to allow the hijacked owner of the vehicle to drive away from the location of the incident and to maintain a sufficient distance from the vehicle in which it is stuck before the system can reactivate.

In addition to the standard CANbus immobiliser blocking capabilities of the Ghost, it has an additional level of security that prevents common methods of hacking employed to gain access to modern vehicles like relay attacks, key range extending and ECU swapping. The autowatch ghost 2 immobiliser system communicates in a non-intrusive way and does not emit signals that can be picked by a thief using code-grabbing technology or RF scanning.

The Ghost system also has the option of a Service/Valet mode that allows your vehicle to be temporarily re-started and driven without the need for a PIN code. This is great when you park your vehicle and only need to leave it for a brief time for a few minutes, like to open the garage door or put groceries in the boot. The system will then exit the service mode based on the speed and duration or through the simple input of a PIN code process. This gives you total peace-of-mind that only YOU can drive your vehicle!

Keyless Entry

Many consumers are now looking for extra security measures because of the growing trend of contactless car theft. This is particularly true for those who have put time or money in personalizing their vehicle and own rare/expensive vehicles. Immobilisers that are added to your vehicle can be a good way to prevent this kind of theft because they will stop your vehicle from starting until correct pin code is entered along with your key fob.

Immobilisers are designed to impede a variety of vehicle circuits which include those that control the starter motor and fuel pump. They can also shut off the car alarm in order to draw attention and scare away potential thieves.

These devices communicate with the engine control unit (ECU) through the CAN data circuit and they stop thieves from trying to get around it by installing a brand new ECU or using a key programmer. These immobilisers are put in place discreetly and leave no marks in your vehicle. They are also unnoticeable with the latest tools of thieves.

Unlike other systems that require a separate app, or a tag that is worn on the person of the driver, a Ghost immobiliser can only be disarmed by pressing a series of the existing electronic buttons on your steering wheel, door panel and central console, allowing you to choose a custom pin sequence. The pin can be changed as frequently as you'd like, meaning the device is as secure as a credit card. It can be even more difficult to crack due to the fact that it requires at least 20 presses.

Ghost also comes with a Valet/Service mode, which permits users to deactivate it when you intend to give your vehicle to valet parking, or for service. This allows the system to function within certain parameters, such as a 30-mph speed limit. The system can be reactivated using the original key or entry code.

Installed by our reputable installers and certified installers, it is the most secure and effective aftermarket CAN-immobiliser that is available. It is also fully certified by Thatcham for insurance purposes. The Ghost 2 immobiliser comes with six QR fingerprint labels, as well as an ISR contact card that contains your unique QR codes and an emergency code that How Much Is A Ghost Immobiliser secure. They are all stored in your wallet or purse.